How to Install Cabinet Door Pulls
Once you finish a cabinet remodel you still need to install the new cabinet pulls. There are a few simple tricks to use to ensure the job goes quickly, smoothly and will look great. So here’s a quick guide on how to install cabinet door pulls.
The first thing you’ll need to do is figure out just where you want to put up the new door pulls. Use a little bit of paste to tack the first cabinet pull up onto the cabinet door. You can adjust the pull up, down, left or right until it looks just right.
Now go to the furthest cabinet and stick up another knob in the same general location. Adjust it until it’s in line with the first handle you stuck into place.
Grab a chalk line and a buddy.
Snap the chalk line across the row of cabinets above and below the two knobs you stuck up with the paste. This gives you a reference point for the height of the door pulls. You won’t have to worry about them sitting uneven on the door fronts.
Now you can just measure how deep the door pull is from the edge of the cabinet and you have the measurements you need to install all of the cabinet door pulls.
Now you’ll want to construct a quick template so that all the pulls go up in the same location.
Grab a piece of wood and mark off the offset you just measured.
Drill holes through the wood that line up with the cabinet door pull and attach bolts.
Now you can take the template and hold it up to cabinet door. Stick a pencil through the door and mark the front of the cabinet.
Next use a cordless drill to put holes in all the cabinet doors at the same time. This will save you time from having to switch out between screwdriver and drill after each cabinet.
Once you drilled out all the pilot holes grab one of the bolts from the cabinet and use it as a test fit. Increase the size of your drill bits until you reach the size of the bolt.
Go back and enlarge all the holes to the same size.
Now you can put down the drill and switch to the screwdriver for good.
Slide each bolt through the back of the cabinet doors. Use the screwdriver to tighten the cabinet pulls to the door facing. You don’t want to crank down too hard on the screws you’ll risk stripping the screws and warping the door pulls.
All that’s left to do is clean up all the saw dust from the drilling. Just vacuum it all up and you’re finished!
Hopefully this guide on how to install cabinet door pulls will make your remodeling job a little easier. These are but a few tips to make the job go smoothly. Just snap a few chalk lines make a template and you’ll have new cabinet pulls up in a few short hours.
Author Jennifer Akre is an owner of a wide variety of online specialty shops including that offer both items and information on how you can easily furnish and decorate your space. Whether it is knobs for your bathroom or cabinet hardware for your kitchen there are many tips you can use to make those spots both functional and beautiful. Click today and indulge your senses.
Article Source: http://EzineArticles.com/?expert=Jennifer_Akre
Categories
